振动工程学报
振動工程學報
진동공정학보
JOURNAL OF VIBRATION ENGINEERING
2015年
4期
567-573
,共7页
王芝%吴维亮%肖黎%屈文忠
王芝%吳維亮%肖黎%屈文忠
왕지%오유량%초려%굴문충
损伤检测%闭合型裂纹%非线性超声%亚谐波%阈值
損傷檢測%閉閤型裂紋%非線性超聲%亞諧波%閾值
손상검측%폐합형렬문%비선성초성%아해파%역치
damage detection%closed crack%nonlinear ultrasonic%subharmonic%threshold behavior
近年来结构健康监测与损伤识别研究中广泛采用非线性振动与非线性超声方法。由于作动器和测试设备环节产生的超谐波成分作为背景噪声掩盖了损伤信号,降低了信噪比,利用亚谐波信号成分来识别闭合型疲劳裂纹。建立了闭合型裂纹的单自由度定性模型,分段迟滞型作用力模拟了裂纹界面间的相互作用以及裂纹张开与闭合过程,研究了产生亚谐波的激励频率和激励幅值条件,讨论了模型参数对亚谐波产生的阈值影响。利用压电作动器/传感器进行了铝制裂纹梁损伤检测实验,得到了裂纹损伤亚谐波识别的激励电压与频率的范围。数值仿真与实验结果表明了闭合型疲劳裂纹的亚谐波损伤识别方法的有效性。
近年來結構健康鑑測與損傷識彆研究中廣汎採用非線性振動與非線性超聲方法。由于作動器和測試設備環節產生的超諧波成分作為揹景譟聲掩蓋瞭損傷信號,降低瞭信譟比,利用亞諧波信號成分來識彆閉閤型疲勞裂紋。建立瞭閉閤型裂紋的單自由度定性模型,分段遲滯型作用力模擬瞭裂紋界麵間的相互作用以及裂紋張開與閉閤過程,研究瞭產生亞諧波的激勵頻率和激勵幅值條件,討論瞭模型參數對亞諧波產生的閾值影響。利用壓電作動器/傳感器進行瞭鋁製裂紋樑損傷檢測實驗,得到瞭裂紋損傷亞諧波識彆的激勵電壓與頻率的範圍。數值倣真與實驗結果錶明瞭閉閤型疲勞裂紋的亞諧波損傷識彆方法的有效性。
근년래결구건강감측여손상식별연구중엄범채용비선성진동여비선성초성방법。유우작동기화측시설비배절산생적초해파성분작위배경조성엄개료손상신호,강저료신조비,이용아해파신호성분래식별폐합형피로렬문。건립료폐합형렬문적단자유도정성모형,분단지체형작용력모의료렬문계면간적상호작용이급렬문장개여폐합과정,연구료산생아해파적격려빈솔화격려폭치조건,토론료모형삼수대아해파산생적역치영향。이용압전작동기/전감기진행료려제렬문량손상검측실험,득도료렬문손상아해파식별적격려전압여빈솔적범위。수치방진여실험결과표명료폐합형피로렬문적아해파손상식별방법적유효성。
In recent years ,researchers have focused on more efficient procedures in SHM and damage detection using nonlinear vibration and nonlinear acoustic methods .Because superharmonics are also generated by the piezoelectric transducers and by the electronic equipments ,these harmonics increase the background noise deteriorating the S/N ratio .The objective of the paper is to demonstrate the application of nonlinear ultrasonic subharmonic method for detecting fatigue crack .The closed fatigue crack is qualitatively modeled as a single‐degree‐of‐freedom (SDOF) system with non‐classical hysteretic nonlinear interface force at both sides of the crack interface .The threshold of subharmonic is discussed and the influence of model parameters on the sub‐harmonic resonance parameter condition is investigated .An aluminum beam with a fatigue crack is used to quantitatively verify the excitation voltage amplitude and frequency subharmonic resonance region .Two surface‐bonded piezoelectric transducers are used to generate and receive ultrasonic wave signals .The experimental results demonstrate that the subharmonic components increase in magnitude with increasing amplitude of the input signal and can be used to accurately detect the fatigue cracks.