CAJ | 학술논문

利用电子背散射衍射技术(EBSD)，研究7085-T7452铝合金双面搅拌摩擦焊缝组织演变规律。结果表明：相对于7085-T7452铝合金母材，双面搅拌摩擦焊缝的晶粒发生明显细化，焊缝的大角度晶界体积分数在300 r/min的旋转速度时较高(75%以上)，随着旋转速度升高到950 r/min而降低。热?机影响区被拉长晶粒和热影响区部分等轴粗大晶粒的平均尺寸分别是7.3和15.7μm，且大角度晶界体积分数分别为43%和30%。与母材相比，双面搅拌摩擦焊缝焊核区(100)、(110)和(111)极图的强度降低，且沿板厚方向存在较大的差异。
이용전자배산사연사기술(EBSD)，연구7085-T7452려합금쌍면교반마찰한봉조직연변규률。결과표명：상대우7085-T7452려합금모재，쌍면교반마찰한봉적정립발생명현세화，한봉적대각도정계체적분수재300 r/min적선전속도시교고(75%이상)，수착선전속도승고도950 r/min이강저。열?궤영향구피랍장정립화열영향구부분등축조대정립적평균척촌분별시7.3화15.7μm，차대각도정계체적분수분별위43%화30%。여모재상비，쌍면교반마찰한봉한핵구(100)、(110)화(111)겁도적강도강저，차연판후방향존재교대적차이。
The microstructure evolution in the weld zone of double-side friction stir welded (DS-FSWed) 7085-T7452 Al alloy was investigated by the electron backscatter diffraction method. The results indicate that DS-FSW process results in substantial grain refinement. The misorientation angle distribution shows a very high volume fraction of high angle grain boundary (HAGB) (above 75%) under DS-FSW condition at rotational rate of 300 r/min. The fraction of HAGB rapidly decreases with increasing the rotational rate from 300 to 950 r/min, and the obvious growth of grain in the weld nugget zone (WNZ) is presented. The average grain sizes in the elongated grains of thermal?mechanical affected zone (TMAZ) and partially equiaxed and coarser grains of thermal affected zone (HAZ) are 7.3 and 15.7μm with the fractions of HAGBs less than 43%and 30%, respectively. The intensities of (100), (110) and (111) pole figures in the WNZ obviously decrease when compared with those in the BM and present significantly difference along the thickness direction of plate.