模具技术
模具技術
모구기술
Die and Mould Technology
2015年
5期
53-56
,共4页
型腔%充填不足%Moldflow分析%壁薄
型腔%充填不足%Moldflow分析%壁薄
형강%충전불족%Moldflow분석%벽박
cavity%incomplete filling%Moldflow analysis%thin wall
运用M oldflow 模拟分析了通过经验设计的一手机外壳型腔的充填过程 ,发现了壳体中间困气缺胶造成充填不足的缺陷.通过分析造成充填不足的因素 ,将壳体中间壁薄处增厚0 .05 mm ,经Moldflow分析,缺陷消失 ,经试模产品符合设计要求.结果表明,在经验设计中引入数值模拟提高了试模效率 ,有效地缩短了产品的开发周期.
運用M oldflow 模擬分析瞭通過經驗設計的一手機外殼型腔的充填過程 ,髮現瞭殼體中間睏氣缺膠造成充填不足的缺陷.通過分析造成充填不足的因素 ,將殼體中間壁薄處增厚0 .05 mm ,經Moldflow分析,缺陷消失 ,經試模產品符閤設計要求.結果錶明,在經驗設計中引入數值模擬提高瞭試模效率 ,有效地縮短瞭產品的開髮週期.
운용M oldflow 모의분석료통과경험설계적일수궤외각형강적충전과정 ,발현료각체중간곤기결효조성충전불족적결함.통과분석조성충전불족적인소 ,장각체중간벽박처증후0 .05 mm ,경Moldflow분석,결함소실 ,경시모산품부합설계요구.결과표명,재경험설계중인입수치모의제고료시모효솔 ,유효지축단료산품적개발주기.
The injection molding process of mobile phone shell was simulated and analyzed by Moldflow ,incomplete filling caused by trapped gas was found .After the analysis of the fac-tors causing insufficient filling ,the intermediate thin wall was determined to be thickened 0 .05mm .The simulation of new solution using Moldflow showed that the defect was disap-peared .Mould trial proved that the appearance and quality meets the design requirements . The use of experience design combined with CAE simulation greatly improve the production benefit .
