流体机械
流體機械
류체궤계
Fluid Machinery
2015年
10期
67-72
,共6页
毛细管吊顶%独立新风%温度分布
毛細管弔頂%獨立新風%溫度分佈
모세관조정%독립신풍%온도분포
capillary ceiling%dedicated outdoor air%temperature distribution
通过搭建毛细管吊顶加独立新风系统试验平台,测试了不同供水温度和供水流量下,毛细管吊顶的换热效果、室内空气垂直温度分布和围护结构温度分布;进一步,在毛细管吊顶联合独立新风系统运行工况下,测试了室内垂直温度分布和围护结构温度相应特性。试验测试结果表明,回水温度值越高,在测试时间内毛细管吊顶的平均换热量越大;供水流量值越大,毛细管吊顶换热量越大。毛细管吊顶单独供暖时,室内0.5到2m 竖直高度方向存在2℃温差,吊顶不同测点最大温差在2℃左右。毛细管吊顶联合独立新风系统供暖时,室内竖向温度变化不明显,吊顶不同测点最大温差在1℃左右。
通過搭建毛細管弔頂加獨立新風繫統試驗平檯,測試瞭不同供水溫度和供水流量下,毛細管弔頂的換熱效果、室內空氣垂直溫度分佈和圍護結構溫度分佈;進一步,在毛細管弔頂聯閤獨立新風繫統運行工況下,測試瞭室內垂直溫度分佈和圍護結構溫度相應特性。試驗測試結果錶明,迴水溫度值越高,在測試時間內毛細管弔頂的平均換熱量越大;供水流量值越大,毛細管弔頂換熱量越大。毛細管弔頂單獨供暖時,室內0.5到2m 豎直高度方嚮存在2℃溫差,弔頂不同測點最大溫差在2℃左右。毛細管弔頂聯閤獨立新風繫統供暖時,室內豎嚮溫度變化不明顯,弔頂不同測點最大溫差在1℃左右。
통과탑건모세관조정가독립신풍계통시험평태,측시료불동공수온도화공수류량하,모세관조정적환열효과、실내공기수직온도분포화위호결구온도분포;진일보,재모세관조정연합독립신풍계통운행공황하,측시료실내수직온도분포화위호결구온도상응특성。시험측시결과표명,회수온도치월고,재측시시간내모세관조정적평균환열량월대;공수류량치월대,모세관조정환열량월대。모세관조정단독공난시,실내0.5도2m 수직고도방향존재2℃온차,조정불동측점최대온차재2℃좌우。모세관조정연합독립신풍계통공난시,실내수향온도변화불명현,조정불동측점최대온차재1℃좌우。
By building the capillary ceiling and dedicated outdoor air system,the heat transfer of capillary ceiling,the vertical temperature distribution of indoor air and the temperature distribution of envelope have been tested in different water temperatures and water flow.Further,in the condition of capillary ceiling joint dedicated outdoor air system operating,the vertical temperature distribution of indoor air and the temperature distribution of envelope have been tested.The experimental results indicate that, the higher the temperature of return water,the greater the average heat transfer of capillary ceiling during the time of testing;the greater the water flow value,the greater the average heat transfer of capillary ceiling.When the capillary ceiling is heating alone, there is 2 ℃ temperature difference between 0.5 meter height and 2 meter height;The maximum temperature difference of the different points of the ceiling is about 2 ℃.When capillary ceiling joint dedicated outdoor air system is heating,the vertical tem-perature difference of the indoor air is not obvious,maximum temperature of different measurement points of the ceiling is around 1℃.