农业工程学报
農業工程學報
농업공정학보
Transactions of the Chinese Society of Agricultural Engineering
2015年
21期
102-108
,共7页
何培祥%汪洋%何家成%梁永江
何培祥%汪洋%何傢成%樑永江
하배상%왕양%하가성%량영강
温室%机械化%设计%磁力轮%塑料大棚%清洗装置%透光率%驱动力
溫室%機械化%設計%磁力輪%塑料大棚%清洗裝置%透光率%驅動力
온실%궤계화%설계%자력륜%소료대붕%청세장치%투광솔%구동력
greenhouses%mechanization%design%magnetic wheels%plastic greenhouses%cleaning device%transmittance%driving force
针对塑料大棚清洗困难的问题,设计了一种磁力轮式塑料大棚清洗装置。该装置主要由磁力轮式行走机构和毛刷清洗机构组成,其核心部件分别为磁力轮、行走电机、毛刷和清洗电机。工作时,由行走电机驱动磁力轮靠磁力吸附在大棚钢制骨架上行走,并由清洗电机驱动毛刷进行清洗工作。该装置适用于骨架间距1 m的拱形钢架塑料大棚,对大棚跨度和脊高无特殊要求。试验结果与分析表明,在纯自来水和洗涤液条件下,大棚透光率分别从清洗前最低的50.9%和49.0%提高至清洗后最高的88.4%和88.9%,最佳清洗流量分别为1.0和1.2 L/min;磁力轮行走机构最小驱动力69 N,满足行走要求;清洗装置平均工作效率6.6 m2/min;大棚倾角变化时,透光率整体平均提高46.7%,使用效果良好。该研究解决了塑料大棚清洗难题,延长了大棚使用寿命,增加了大棚维护安全性。
針對塑料大棚清洗睏難的問題,設計瞭一種磁力輪式塑料大棚清洗裝置。該裝置主要由磁力輪式行走機構和毛刷清洗機構組成,其覈心部件分彆為磁力輪、行走電機、毛刷和清洗電機。工作時,由行走電機驅動磁力輪靠磁力吸附在大棚鋼製骨架上行走,併由清洗電機驅動毛刷進行清洗工作。該裝置適用于骨架間距1 m的拱形鋼架塑料大棚,對大棚跨度和脊高無特殊要求。試驗結果與分析錶明,在純自來水和洗滌液條件下,大棚透光率分彆從清洗前最低的50.9%和49.0%提高至清洗後最高的88.4%和88.9%,最佳清洗流量分彆為1.0和1.2 L/min;磁力輪行走機構最小驅動力69 N,滿足行走要求;清洗裝置平均工作效率6.6 m2/min;大棚傾角變化時,透光率整體平均提高46.7%,使用效果良好。該研究解決瞭塑料大棚清洗難題,延長瞭大棚使用壽命,增加瞭大棚維護安全性。
침대소료대붕청세곤난적문제,설계료일충자력륜식소료대붕청세장치。해장치주요유자력륜식행주궤구화모쇄청세궤구조성,기핵심부건분별위자력륜、행주전궤、모쇄화청세전궤。공작시,유행주전궤구동자력륜고자력흡부재대붕강제골가상행주,병유청세전궤구동모쇄진행청세공작。해장치괄용우골가간거1 m적공형강가소료대붕,대대붕과도화척고무특수요구。시험결과여분석표명,재순자래수화세조액조건하,대붕투광솔분별종청세전최저적50.9%화49.0%제고지청세후최고적88.4%화88.9%,최가청세류량분별위1.0화1.2 L/min;자력륜행주궤구최소구동력69 N,만족행주요구;청세장치평균공작효솔6.6 m2/min;대붕경각변화시,투광솔정체평균제고46.7%,사용효과량호。해연구해결료소료대붕청세난제,연장료대붕사용수명,증가료대붕유호안전성。
The technology of plastic greenhouses is widely used in China. Greenhouses’ films get dirty easily with dusts and mosses with the increasing of use time. That’s the reason why its transmittance (which is one of the important factors that affect the greenhouses’ productivity) decreases. Nowadays, cleaning devices are mainly designed for glass curtain walls, ventilating ducts and air conditioner pipes. These cleaning devices have difficulties in cleaning plastic greenhouses because of the greenhouses’ arc frames and the films’ variable surfaces. To solve the problems, a cleaning device with magnetic wheels was designed in this paper. The cleaning device consists of magnetic wheel walking mechanism and brush cleaning mechanism, whose core components are magnetic wheels, walking motors, brushes and cleaning motors. When greenhouses need cleaning, put the device on the greenhouses’ canopy and provide power for it. Thus, the walking motors can drive the magnetic wheels to walk forward on the greenhouses’ frame by magnetic absorption. Meanwhile, the cleaning motors also drive the brushes to clean the greenhouses with water or detergent for the first time. When the device walks to the top of the canopy, manually shift the power switch to make walking motors rotate reversely, then, the device can walk back and operate the second cleaning work. When the device returns to the bottom of the greenhouses’ frame, it should be translated to the neighboring frame for the next cleaning work. The device’s minimum driving force and magnetic force were calculated by the device’s mechanical model and its force situation analysis, which was essential for walking on the greenhouses’ frames. The analysis results showed that the driving force and magnetic force needed at least 58.9 and 235.6 N, respectively. And each magnetic wheel’s magnetic force was no less than 58.9 N. In order to verify whether the magnetic wheel met the requirements of minimum magnetic force, the magnetic force analysis was taken in ANSYS and the analysis results indicated that each magnetic wheel’ magnetic force was 67 N, which had met the requirements. In order to balance the cleaning effect and working efficiency, the device’s theoretical walking speed was computed and designed to 0.13 m/s. Based on the design and calculation of the magnetic force, driving force and walking speed, the cleaning device can walk safely and stably on the arc frame of plastic greenhouses with skeleton spacing of 1 m and ridge height of 4.7 m in theory. To test if the cleaning device can walk safely and stably on the arc frame of plastic greenhouses in practice and achieve a good cleaning effect, researchers did the walking velocity and cleaning effect experiment, the driving force experiment and the using effect experiment. The walking velocity and cleaning effect experiment’s results showed that: 1) the device’s walking was stable at the velocity of 6.6 m/min; 2) its average work efficiency could reach 6.6 m2/min; 3) the transmittance of plastic greenhouses was increased from 50.9% to 88.4% and from 49.0% to 88.9% after the cleaning of water and detergent, respectively; 4) the best cleaning water and detergent consumption were 1.2 L and 1.0 L per minute. The driving force experiment’s results indicated that the minimum driving force of the device was 69 N, which was greater than the theoretical calculation value and met the walking requests. The using effect experiment’s results showed that the transmittance increased by 46.7% when the greenhouse’ dip angle changed, which manifested this cleaning device had a good effect in use. This study solves the difficulty of plastic greenhouses cleaning, which can provide some reference for plastic greenhouses’ design.