公路工程
公路工程
공로공정
Highway Engineering
2015年
5期
261-264
,共4页
改性沥青%Sasobit%粘度%温度%剪切速率
改性瀝青%Sasobit%粘度%溫度%剪切速率
개성력청%Sasobit%점도%온도%전절속솔
modified asphalt%sasobit%viscosity%temperature%shear rate
该研究中,在28~130℃温度范围,间隔6℃测量动态粘度(η’)。从粘度分析中可得出以下结论:对 Sasobit 改性沥青存在一个临界温度,在临界温度之上 Sasobit 降低粘度;在临界温度之下 Sasobit 增加粘度。此外,在0.0025~250 s -1剪切速率范围内,分析了掺加及未参加 Sasobit 沥青的稳态剪切黏度对剪切速率的依赖性。掺加 Sasobit 后,在64℃下 PG64-22沥青变为剪切变稀型流体。剪切速率依赖性随着 Sasobit 掺量的增加而增加。在100℃下观察到了 Sasobit 相似的效果。对 PG76-22M沥青,在所有3个温度下,随着 Sasobit 掺量增加,剪切速率依赖性增加。这表明,如果现场实际的剪切速率高于粘度测量所使用的剪切速率,目前正使用的拌和及压实温度可能较低。
該研究中,在28~130℃溫度範圍,間隔6℃測量動態粘度(η’)。從粘度分析中可得齣以下結論:對 Sasobit 改性瀝青存在一箇臨界溫度,在臨界溫度之上 Sasobit 降低粘度;在臨界溫度之下 Sasobit 增加粘度。此外,在0.0025~250 s -1剪切速率範圍內,分析瞭摻加及未參加 Sasobit 瀝青的穩態剪切黏度對剪切速率的依賴性。摻加 Sasobit 後,在64℃下 PG64-22瀝青變為剪切變稀型流體。剪切速率依賴性隨著 Sasobit 摻量的增加而增加。在100℃下觀察到瞭 Sasobit 相似的效果。對 PG76-22M瀝青,在所有3箇溫度下,隨著 Sasobit 摻量增加,剪切速率依賴性增加。這錶明,如果現場實際的剪切速率高于粘度測量所使用的剪切速率,目前正使用的拌和及壓實溫度可能較低。
해연구중,재28~130℃온도범위,간격6℃측량동태점도(η’)。종점도분석중가득출이하결론:대 Sasobit 개성력청존재일개림계온도,재림계온도지상 Sasobit 강저점도;재림계온도지하 Sasobit 증가점도。차외,재0.0025~250 s -1전절속솔범위내,분석료참가급미삼가 Sasobit 력청적은태전절점도대전절속솔적의뢰성。참가 Sasobit 후,재64℃하 PG64-22력청변위전절변희형류체。전절속솔의뢰성수착 Sasobit 참량적증가이증가。재100℃하관찰도료 Sasobit 상사적효과。대 PG76-22M력청,재소유3개온도하,수착 Sasobit 참량증가,전절속솔의뢰성증가。저표명,여과현장실제적전절속솔고우점도측량소사용적전절속솔,목전정사용적반화급압실온도가능교저。
In this study,dynamic viscosity was measured at temperature ranges from 28 ℃ to 130℃ at 6 ℃ interval.From viscosity analyses it can be concluded that there exists a critical temperature for a Sasobit modified asphalt such that above the critical temperature Sasobit reduces the viscosity and below that temperature Sasobit increases the viscosity.Also,the shear rate dependency of steady state viscosity of asphalt binders with and without Sasobit was analyzed in this study with in the range of 0.002 5 /s to 250 /s.With the addition of Sasobit,PG 64 -22 at 64 ℃ becomes a shear-thinning liquid.The shear rate de-pendency increases with an increase in percent of Sasobit.Similar effects of Sasobit are observed at 100℃ in reduced level and shear rate dependency with the addition of Sasobit is almost negligible at 124 ℃.Also,the rate of change of viscosity is higher at higher shear rates and lower at lower shear rates.