工业用水与废水
工業用水與廢水
공업용수여폐수
Industrial Water & Wastewater
2015年
5期
65-68
,共4页
光伏废水%回用%双膜法%超滤%反渗透
光伏廢水%迴用%雙膜法%超濾%反滲透
광복폐수%회용%쌍막법%초려%반삼투
photovoltaic wastewater%reuse%dual-membrane%ultrafiltration%reverse osmosis
针对多晶硅生产废水的水质特点,及回用水对总溶解固体和氟离子浓度要求较高的情况,江苏省某企业设计采用了AO生化-絮凝沉淀-超滤-反渗透组合工艺进行处理回用,工程设计规模为1万t/d。工程运行结果表明,在进水CODCr、 NH3-N、 NO3--N、 TDS、 F-的质量浓度分别为570.6、4.30、34.20、4737.5、21.90 mg/L时,出水CODCr、 NH3-N、 NO3--N、 TDS、 F-的质量浓度分别为37.0、0.09、0.34、108.0、0.39 mg/L,出水水质满足GB/T 19923-2005《城市污水再生利用工业用水水质》中的工艺与产品用水标准,同时F-的质量浓度在0.5 mg/L以下,完全达到企业的回用要求。介绍了工艺流程和各构筑物的主要设计参数。
針對多晶硅生產廢水的水質特點,及迴用水對總溶解固體和氟離子濃度要求較高的情況,江囌省某企業設計採用瞭AO生化-絮凝沉澱-超濾-反滲透組閤工藝進行處理迴用,工程設計規模為1萬t/d。工程運行結果錶明,在進水CODCr、 NH3-N、 NO3--N、 TDS、 F-的質量濃度分彆為570.6、4.30、34.20、4737.5、21.90 mg/L時,齣水CODCr、 NH3-N、 NO3--N、 TDS、 F-的質量濃度分彆為37.0、0.09、0.34、108.0、0.39 mg/L,齣水水質滿足GB/T 19923-2005《城市汙水再生利用工業用水水質》中的工藝與產品用水標準,同時F-的質量濃度在0.5 mg/L以下,完全達到企業的迴用要求。介紹瞭工藝流程和各構築物的主要設計參數。
침대다정규생산폐수적수질특점,급회용수대총용해고체화불리자농도요구교고적정황,강소성모기업설계채용료AO생화-서응침정-초려-반삼투조합공예진행처리회용,공정설계규모위1만t/d。공정운행결과표명,재진수CODCr、 NH3-N、 NO3--N、 TDS、 F-적질량농도분별위570.6、4.30、34.20、4737.5、21.90 mg/L시,출수CODCr、 NH3-N、 NO3--N、 TDS、 F-적질량농도분별위37.0、0.09、0.34、108.0、0.39 mg/L,출수수질만족GB/T 19923-2005《성시오수재생이용공업용수수질》중적공예여산품용수표준,동시F-적질량농도재0.5 mg/L이하,완전체도기업적회용요구。개소료공예류정화각구축물적주요설계삼수。
In view of the characteristics of wastewater from polycrystalline silicon production, and consider-ing the strict requirement of wastewater reutilization about total dissolved solids(TDS) and fluorinion concentra-tions AO biochemical-flocculation sedimentation-ultrafiltration-reverse osmosis combined process was adopted by a company in Jiangsu province for the treatment and reuse of the said kind of wastewater, the engineering de-sign scale was 10 000 t/d. The running result of the project showed that, when the mass concentrations of CODCr, NH3-N, NO3--N, TDS, F-of the influent water were 570.6、 4.30、 34.20、 4 737.5 and 21.90 mg/L respectively, the corresponding indexes of the effluent water were 37.0、 0.09、 0.34、 108.0 and 0.39 mg/L respectively, the effluent water quality met the requirement of water quality standard for craft and product in GB/T 19923-2005 The Reuse of Urban Recycling Water―Water Quality Standard for Industrial Uses. Besides, the mass concentra-tion of F-was lower than 0.5 mg/L, which totally met the demand of reuse water quality for the company. In addi-tion, the process flow and the main design parameters of structures were also introduced.