矿冶工程
礦冶工程
광야공정
Mining and Metallurgical Engineering
2015年
5期
4-9
,共6页
施耀斌%叶义成%王其虎%岳哲%鲁方%夏张琦
施耀斌%葉義成%王其虎%嶽哲%魯方%夏張琦
시요빈%협의성%왕기호%악철%로방%하장기
条带法%开采强度%矿柱%数值模拟%相似模拟%缓倾斜多层矿床
條帶法%開採彊度%礦柱%數值模擬%相似模擬%緩傾斜多層礦床
조대법%개채강도%광주%수치모의%상사모의%완경사다층광상
strip mining%mining intensity%pillar%numerical simulation%similar simulation%multi-layer gently dipping deposit
为了实现高效安全开采,以上横山缓倾斜多层矿床为研究对象,采用数值模拟和物理相似模拟试验,分析了条带法开采矿柱的变形特征. 结果表明:矿柱变形首先在端面尖点等软弱处产生,端面应变随回采进行不断积聚,变形呈不连续、非均匀分布和变化;当矿柱两侧均为采空区时,其下端面尖点和上端面低水平尖点均为高拉应变状态,应变量较上一时步增幅为 2. 95%~145.55%;当矿柱处于充填体上覆岩层内时,其中心应变均为变幅为5.67%~63.98%的压应变. 矿柱的下层围岩或充填体的完整性和连续性是影响其稳定性和有效性的重要因素. 考虑矿柱合理变形和采场的稳定性,确定最大不充填开采条带数为3条. 工业性实践应用表明该开采强度能满足高效安全开采的要求.
為瞭實現高效安全開採,以上橫山緩傾斜多層礦床為研究對象,採用數值模擬和物理相似模擬試驗,分析瞭條帶法開採礦柱的變形特徵. 結果錶明:礦柱變形首先在耑麵尖點等軟弱處產生,耑麵應變隨迴採進行不斷積聚,變形呈不連續、非均勻分佈和變化;噹礦柱兩側均為採空區時,其下耑麵尖點和上耑麵低水平尖點均為高拉應變狀態,應變量較上一時步增幅為 2. 95%~145.55%;噹礦柱處于充填體上覆巖層內時,其中心應變均為變幅為5.67%~63.98%的壓應變. 礦柱的下層圍巖或充填體的完整性和連續性是影響其穩定性和有效性的重要因素. 攷慮礦柱閤理變形和採場的穩定性,確定最大不充填開採條帶數為3條. 工業性實踐應用錶明該開採彊度能滿足高效安全開採的要求.
위료실현고효안전개채,이상횡산완경사다층광상위연구대상,채용수치모의화물리상사모의시험,분석료조대법개채광주적변형특정. 결과표명:광주변형수선재단면첨점등연약처산생,단면응변수회채진행불단적취,변형정불련속、비균균분포화변화;당광주량측균위채공구시,기하단면첨점화상단면저수평첨점균위고랍응변상태,응변량교상일시보증폭위 2. 95%~145.55%;당광주처우충전체상복암층내시,기중심응변균위변폭위5.67%~63.98%적압응변. 광주적하층위암혹충전체적완정성화련속성시영향기은정성화유효성적중요인소. 고필광주합리변형화채장적은정성,학정최대불충전개채조대수위3조. 공업성실천응용표명해개채강도능만족고효안전개채적요구.
Aiming at Shanghengshan multilayer deposits in gently dipping strata, the deformation characteristics of pillar in strip mining were analyzed based on the numerical simulation and physical simulation tests, so as to ensure effective and safe mining on mine. Results showed that as the panel mined, pillar deformation firstly occurred on failure points, such as the upper end of the pillar. The strain on upper end was increasingly accumulated with the progressing of stoping, resulting in the deformation distributed and varied discontinuously and unevenly. With both sides being mind-out area, the pillars were in a high strain state especially at the upper end and bottom end, with compressive strain increased by 2.95%~145.55% than the previous step. As the orebody underneath the pillar was backfilled, the central strain of the pillar was the compressive strain with variation of 5.67%~63.98%. Thus the integrity and continuity of backfills and surrounding rock underneath the pillar play an important role in keeping pillar′s stability. Based on the consideration of pillar′s deformation and stope′s stability, it is suggested that maximally three strips be minded out without backfilling in the strip mining of such kind of deposit. On-site practice indicates such mining intensity can ensure the safety of the efficient mining.