现代电子技术
現代電子技術
현대전자기술
Modern Electronics Technique
2015年
22期
126-130
,共5页
模拟电荷法%参数计算%工频电场强度%部分架设%Matlab
模擬電荷法%參數計算%工頻電場彊度%部分架設%Matlab
모의전하법%삼수계산%공빈전장강도%부분가설%Matlab
charge simulation method%parameter calculation%power frequency electric field strength%part erection%Matlab
为深入研究超高压输电线路下方工频电场强度和改善措施,首先根据电磁场理论对输电线路的参数进行计算,得出沿线电压的分布.考虑沿线电压不同后,采用模拟电荷法对输电线下方1.5 m处的工频电场强度进行分析,并利用ANSYS软件对模拟电荷法进行验证.结果发现只需部分架设屏蔽线就可以满足要求,这样也可以节省成本.然后分析得出架设屏蔽线的合理位置.最后利用Matlab仿真得出输电线路下方部分架设屏蔽线的工频电场曲线,研究结果表明,部分架设屏蔽线可以改善输电线路的工频电场.
為深入研究超高壓輸電線路下方工頻電場彊度和改善措施,首先根據電磁場理論對輸電線路的參數進行計算,得齣沿線電壓的分佈.攷慮沿線電壓不同後,採用模擬電荷法對輸電線下方1.5 m處的工頻電場彊度進行分析,併利用ANSYS軟件對模擬電荷法進行驗證.結果髮現隻需部分架設屏蔽線就可以滿足要求,這樣也可以節省成本.然後分析得齣架設屏蔽線的閤理位置.最後利用Matlab倣真得齣輸電線路下方部分架設屏蔽線的工頻電場麯線,研究結果錶明,部分架設屏蔽線可以改善輸電線路的工頻電場.
위심입연구초고압수전선로하방공빈전장강도화개선조시,수선근거전자장이론대수전선로적삼수진행계산,득출연선전압적분포.고필연선전압불동후,채용모의전하법대수전선하방1.5 m처적공빈전장강도진행분석,병이용ANSYS연건대모의전하법진행험증.결과발현지수부분가설병폐선취가이만족요구,저양야가이절성성본.연후분석득출가설병폐선적합리위치.최후이용Matlab방진득출수전선로하방부분가설병폐선적공빈전장곡선,연구결과표명,부분가설병폐선가이개선수전선로적공빈전장.
To further study the power frequency electric field strength beneath the extra-high voltage(EHV)transmission line and its improvement measure,the parameters of the transmission line are calculated according to the theory of electromag-netic field to obtain voltage distribution along the line. Considering the voltages along the line are different,the power frequency electric field strength at 1.5 m beneath the transmission line is analyzed with charge simulation method. The charge simulation method was verified with ANSYS software. It is found from the verification results that the erection of just a part shielded wire can meet the requirement,which can save the cost. The reasonable position of the shielded wire was obtained with analysis. Fi-nally,the power frequency electric field curve of transmission line with a part erection shielded wire beneath it was gained by Matlab simulation. The research results show that part erection shielded wire can improve the power frequency electric field of the transmission lines.