实用口腔医学杂志
實用口腔醫學雜誌
실용구강의학잡지
Journal of Practical Stomatology
2015年
6期
801-805
,共5页
整层充填%分层充填%流动树脂%楔状缺损
整層充填%分層充填%流動樹脂%楔狀缺損
정층충전%분층충전%류동수지%설상결손
Bulk-fill%Layer-filled%Flowable resin%Wedge-shaped defect
目的:观察新型整层充填流动树脂一次固化充填深楔状缺损的2年临床效果。方法:纳入左右成对深楔状缺损(深度>2 mm)前磨牙的患者50名,共85对前磨牙,随机分为试验组和对照组,试验组使用整层充填流动树脂一次充填固化,对照组使用传统树脂分层充填固化,比较2组患牙充填后1周牙齿敏感发生率及充填后2年充填体脱落率及边缘染色/继发龋发生率。结果:2组患牙在充填后1周牙齿敏感发生率、充填后2年充填体脱落率、边缘染色/继发龋发生率差异均无显著性(P>0.05)。结论:使用整层充填流动树脂一次固化充填深楔状缺损可达到与传统树脂分层充填相媲美的临床效果。
目的:觀察新型整層充填流動樹脂一次固化充填深楔狀缺損的2年臨床效果。方法:納入左右成對深楔狀缺損(深度>2 mm)前磨牙的患者50名,共85對前磨牙,隨機分為試驗組和對照組,試驗組使用整層充填流動樹脂一次充填固化,對照組使用傳統樹脂分層充填固化,比較2組患牙充填後1週牙齒敏感髮生率及充填後2年充填體脫落率及邊緣染色/繼髮齲髮生率。結果:2組患牙在充填後1週牙齒敏感髮生率、充填後2年充填體脫落率、邊緣染色/繼髮齲髮生率差異均無顯著性(P>0.05)。結論:使用整層充填流動樹脂一次固化充填深楔狀缺損可達到與傳統樹脂分層充填相媲美的臨床效果。
목적:관찰신형정층충전류동수지일차고화충전심설상결손적2년림상효과。방법:납입좌우성대심설상결손(심도>2 mm)전마아적환자50명,공85대전마아,수궤분위시험조화대조조,시험조사용정층충전류동수지일차충전고화,대조조사용전통수지분층충전고화,비교2조환아충전후1주아치민감발생솔급충전후2년충전체탈락솔급변연염색/계발우발생솔。결과:2조환아재충전후1주아치민감발생솔、충전후2년충전체탈락솔、변연염색/계발우발생솔차이균무현저성(P>0.05)。결론:사용정층충전류동수지일차고화충전심설상결손가체도여전통수지분층충전상비미적림상효과。
Objective:To observe the effect of “bulk-fill”flowable resin in filling deep wedge-shaped defects.Methods:50 pa-tients with totally 85 pairs of premolars with deep wedge-shaped defects(depth >2 mm)were included.Each pair of the defects was randomly divided into the test group and the control group,the defects were treated by “bulk-fill”flowable resin with single cure tech-nique and conventional flowable resin with incremental layering technique respectively,the tooth sensitive rate 1 week after filling,the filling failure rate,the edge coloring and secondary caries rate 2 years after filling of the 2 groups were compared.Results:There was no significant difference between the 2 groups in the sensitive rate 1 week after filling,the failure rate and the edge coloring and sec-ondary caries rate 2 years after filling(P >0.05).Conclusion:The “bulk-filled”flowable resin using single cure technique can ac-quire the same clinical effect as conventional flowable resin using incremental layering technique in filling deep wedge-shaped defects.